Heater; Thermistor; Pump - LG WD-10151SUP Service Manual

PUMP

Pump Outlet Hose
Tub Pump
Bellows

HEATER

THERMISTOR

① Remove pump outlet hose.
② Remove tub pump bellows.
③ Remove cap (Remaining Hose.)
④ Disconnect the wiring.
⑤ Unscrew 2 screws.
⑥ Remove the pump.
① Loosen the M6 heater nut to pull out the heater.
CAUTION
When mounting the heater, be sure to insert the heater
into the heater clip on the bottom of the tub.
① Pull it out by holding the thermistor bracket.
If it is pulled by the wire, it may be broken.
② When mounting the thermistor again, make sure that it
is got back tight to the bushing.
29