Table of Contents
Advertisement
The incoming call number is not displayed
through CID.
Caller ID is not enabled.
¥
You must ask the telephone network pro-
vider to activate Caller ID (CID).
You hear an error tone when keying an
input.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions, if necessary.
You cannot listen to messages left on the
voice mailbox.
Your phone system is set for pulse dialing.
¥
Set your phone system to tone dialing.
You hear an error beep from the answering
machine during remote operation.
The system PIN entered is incorrect.
¥
Enter the system PIN again
(see page 30).
You cannot operate the answering machine
using remote operation.
Remote Access is not activated.
¥
Activate Remote Access (see page 23)
The answering machine does not record
messages/has switched to "announce only".
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
Specifications
Recommended batteries
Nickel-metal hydride (NiMH):
The handset is supplied with the author-
ized AAA batteries.
Handset operating times/charging
times
Capacity
550 mAh
Standby time
Approx. 300 hours
(12.5 days)
Talk time
Approx. 10 hours
Charge time
Approx. 10 hours
The operating and charge times apply only
when using the recommended batteries.
Base station power consumption
In standby mode: approx. 1.5 watts
During a call: approx. 2 watts
General specifications
DECT 6.0
is supported
No. of channels
30 duplex channels
Radio frequency
range
1920–1930 MHz
Duplex method
Time multiplex, 10-ms
frame length
Channel grid
1728 kHz
Bitrate
1152 kbit/s
Modulation
GFSK
Language code
32 kbit/s
Transmission
10 mW, average power per
power
channel
Range
Up to 984 feet outdoors,
up to 165 feet indoors
Power supply
input
110 V ~/60 Hz
Environmental
+41°F to +113°F;
operating condi-
20% to 75% relative
tions
humidity
Dialing mode
DTMF (tone dialing)/DP
(pulse dialing)
Appendix
33
Advertisement
Table of Contents
