Doors - Maytag MFX2876DRM User Instructions

PROBLEM
Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip
from the dispenser beyond
the first few drops.
Water is leaking from the
back of the refrigerator
Water from the dispenser is
warm
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for "door closing and door alignment."
PROBLEM
The doors will not close
completely
The doors are difficult to
open
The doors appear to be
uneven
The refrigerator is unsteady
or it rolls forward when
opening and closing doors
28
POSSIBLE CAUSES
The glass was not held under the
dispenser long enough.
The refrigerator has just been
installed.
The water filter was recently installed
or replaced.
The water line connections were not
fully tightened.
Recently removed the doors and did
not fully tighten water line connection
Water from the dispenser is chilled to
50°F (10°C).
The refrigerator has just been
installed.
A large amount of water was recently
dispensed.
Water has not been recently
dispensed.
The refrigerator is not connected to a
cold water pipe.
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
POSSIBLE CAUSES
The door is blocked open.
A bin or shelf is in the way.
Recently installed
The door gaskets are dirty or sticky.
The doors need to be aligned, or the
refrigerator needs to be leveled.
The refrigerator brake feet are not
snug against the floor.
SOLUTIONS
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See "Water and Ice Dispensers."
Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See "Water and Ice Dispensers."
See "Connecting the Water."
See "Refrigerator Doors and Drawer."
This is normal.
Allow 24 hours after installation for the water supply to cool
completely.
Allow 3 hours for the water supply to cool completely.
The first glass of water may not be cool. Discard the first
glass of water dispensed.
Make sure the refrigerator is connected to a cold water pipe.
See "Water Supply Requirements."

Doors

SOLUTIONS
Move food packages away from door.
Push bin or shelf back into the correct position.
Remove all packaging materials.
Clean gaskets and contact surfaces with mild soap and
warm water. Rinse and dry with soft cloth.
See "Refrigerator Leveling, Door Closing and Alignment."
Remove the base grille. Turn both brake feet (one on each
side) clockwise, the same amount, until they are snug against
the floor. See "Refrigerator Leveling, Door Closing and
Alignment."