Related Manuals for MTX SW1010
Summary of Contents for MTX SW1010
- Page 1 SW1010, SW1212, SW1515 1 Mitek Plaza Powered Home Subwoofer Winslow, IL 61089 Owner’s Manual 815-367-3000 800-225-5689 21A6279...
-
Page 2: Care And Maintenance
Your speakers are designed to work with a wide range of electronic components. As little as 20 watts per channel can provide enough power for most applications. If you have a large room or prefer louder listening levels, more power may be required. -
Page 3: Specifications
SPECIFICATIONS SW1010 SW1212 Amplifier Type: Class A/B Class A/B Amplifier Power: 100 Watts 130 Watts Frequency response: 33-120Hz 27-120Hz Inputs: Line level Line level High level High level Outputs: Line level Line level High level Hi-pass subsonic filter: 18dB@30Hz 18dB@25Hz... -
Page 4: In Case Of Trouble
Read Instructions – All the safety and operating should be routed so that they are not likely to be instructions should be read before the product is walked on or pinched by items placed upon or against opened. them, paying particular attention to cords at plugs, convenience receptacles, and the point where they Retain Instructions –... -
Page 5: Table Of Contents
OPERATION After you have connected your subwoofer, adjusted it for proper operation with the rest of your system, and experimented to find the best location for it, it’s time to sit back and enjoy it. As you do, here are some hints for getting the most out of your subwoofer. -
Page 6: Introduction
Your new subwoofer has many features which help to deliver great bass performance and make it a remarkable value. * High efficiency amplifier: The SW1010, SW1212 (class A/B) and SW1515 ( class D) represent the latest amplifier technology with active compression circuits for higher SPL without breakup during high amplitude peaks. -
Page 7: Unpacking/Pre-Installation Instructions
B) For use with A/V preamps and receivers that have 5.1 channel line level outputs. If your preamplifier or receiver has a single “subwoofer” output or “LFE” output, connect a shielded cable from the preamplifier output to either one of the subwoofer line level inputs. -
Page 8: Explanation Of Features And Controls
EXPLANATION OF FEATURES AND CONTROLS Refer to figure A. 1) Polarity switch: This two position switch allows the best match of acoustic output between the subwoofer and the main stereo speakers in the region of the crossover frequency between them. The “normal” position maintains phase from input to output, the “reverse”... - Page 9 B) For amplifiers with two sets of speaker connections. An alternate method of connecting your subwoofer and main speakers is possible if you have a receiver or amplifier that can accommodate two sets of speakers that can be switched on at the same time and be connected in parallel. (Note that some receivers and amplifiers connect “A”...
-
Page 10: Wiring And Connections
PLACEMENT OR POSITIONING Your new subwoofer will work well in a variety of locations. However, placement in your listening room will affect its performance. Since the wavelengths of sound reproduced by your subwoofer are large compared to its size, those sounds are omni-directional in nature.
Need help?
Do you have a question about the SW1010 and is the answer not in the manual?
Questions and answers