Motorola PMLN6716 User Manual page 42


Placing and Removing the WRSM or Battery to and from
the Vehicular Charger
Placing the WRSM or Battery to the Vehicular Charger
The Vehicular Charger will accommodate a WRSM with an attached
battery or battery alone in pocket. To charge a battery, use the following
procedure:
1
Plug in the CLA adaptor to CLA power supply. The charger LED will
flash single green once to indicate a successful power-up.
2
Insert a WRSM with battery into the charger pocket by:
a
Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger pocket per
Figure (R1).
b
Pressing on the front – top surface of the WRSM according to
the direction indicated in Figure (R2) to lock the WRSM into
Vehicular Charger.
3
When the WRSM with battery is properly seated in the pocket, the
charger LED will light in accordance with Table 5.3 per Figure (R3).
4
Insert a battery into the charger pocket by:
a
Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger pocket per
Figure (B1).
b
Pressing on the front – top surface of the battery according to
the direction indicated in Figure (B2) to lock the battery into
Vehicular Charger.
36
English
3
When the battery is properly seated in the pocket, the LED of the
charger will light in accordance with Table 5.3 per Figure (B3).
Removing the WRSM or Battery from the Vehicular Charger
The Vehicular Charger will accommodate a WRSM with an attached
battery or battery alone in pocket. To stop charging a battery, use the
following procedure:
1
Unplug the CLA from the vehicle cigar lighter socket.
2
Remove a WRSM with battery from the charger pocket by:
a
Pressing on the release button of the Vehicular Charge to
unlatch the battery per Figure (R3).
b
Remove the WRSM from the pocket by sliding the WRSM
upward per Figure (R2).
3
Remove a battery from the charger pocket by:
a
Pressing on the release button of the Vehicular Charger to
unlatch the battery per Figure (B3).
b
Remove the battery from the pocket by sliding the battery
upward per Figure (B2).