Connecting The Fm Antenna; Connecting Ipod - Yamaha BRX-610 Owner's Manual

CONNECTION
■ Connecting speaker cables
Each speaker has two speaker cables. One is for
connecting the – (negative) terminal of the unit and the
speaker, and the other is for the + (positive) terminal. The
cables are different colors, so they do not get mixed up.
Connect the black side to the – (negative) terminal and the
other side to the + (positive) terminal.
1 1
1
Remove approximately 10 mm of insulation from the
end of the speaker cable and twist the bare wire
firmly.
2
Press the tab on the speaker terminal down.
3
Insert the bare wire of the speaker cable into the
terminal.
4
Lift the tab to secure the speaker cable.
■ Connecting an active subwoofer
When connecting an active subwoofer (built-in amplifier),
use a monaural pin cable. Before connecting an active
subwoofer, turn it off.
Monaural pin cable
About subwoofer speaker
• Use the speaker terminal to connect a passive
subwoofer speaker. Use the SUBWOOFER output jack
to connect an active subwoofer speaker (built-in
amplifier).
• You can adjust the subwoofer volume level by using
this unit's remote control. For an active subwoofer
speaker (built-in amplifier), you can also use the control
on the subwoofer to adjust volume level. Use these
functions to decrease the volume level if strange noise
or sound is output from the subwoofer.
• If you are not using a subwoofer speaker, select SETUP
menu = [Audio Setting] = [Speaker Setting] =
[Configuration] = [SW] = [Disable].
12
En
2 2
4 4
3 3

Connecting the FM antenna

You can enjoy listening to FM radio stations by
connecting the supplied indoor FM antenna.
Note
If there is a problem of weak radio wave reception in your area or
you want to improve radio reception, we recommend that you use
commercially available outdoor antennas. For details, consult the
nearest authorized Yamaha dealer or service center.

Connecting iPod

You can enjoy music stored in your iPod by connecting it
to this unit.
Note
This unit is compatible with iPod classic, iPod nano (2nd, 3rd,
4th, 5th and 6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS, and iPhone 4.
Notes
• Make sure the USB cable is connected securely between
your iPod and this unit.
• Connect your iPod to the front USB port of this unit. The
rear USB port is not compatible with your iPod.
USB PORTABLE
USB port
iPod/iPhone