Using The Adhesive - Sony FDR-X1000V How To Use Manual

[17] How to use
Using the adhesive mount
The adhesive mount is used for fixing the waterproof case or tripod adaptor to an item you
intend to use. The adhesive mount is a general term for the attachment buckle, flat adhesive
mount, and curved adhesive mount. Before attaching, insert the camera in the waterproof
case or attach the tripod adaptor.
The adhesive mount can be attached to the FDR-X1000V without attaching the
waterproof case or the tripod adaptor.
The procedure for fixing the adhesive mount to the waterproof case is explained here.
1. Align the tripod screw hole in the bottom of the waterproof case with the tripod screw
hole of the attachment buckle, and fix firmly with the tripod screw.
Match the bottom of the camera and fix firmly with the tripod screw.
2. Attach the attachment buckle (with the waterproof case set in step 1) to the flat
adhesive mount or curved adhesive mount by sliding it until it clicks into place.
3. Remove dust, moisture and oily substances completely from the surface where the
adhesive mount is to be attached.
4. Peel off the release paper on the back, and fix the adhesive mount in the desired
location.
Adhesive power reaches its maximum strength 24 hours after the adhesive mount is
attached to the desired location.
To attach to or detach from the attachment buckle
Getting Started Using Adhesive Mount