Timer; Care And Cleaning - Mitsubishi Electric PLA-RP35BA Operation Manual

3. Operation
3.6. Ventilation
For LOSSNAY combination
■
The following 2 patterns of operation is available.
• Run the ventilator together with indoor unit.
• Run the ventilator independently.

4. Timer

■
Timer functions are different by each remote controller.
■
For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.

5. Care and Cleaning

■
Filter information
Fri
Room
Cool Set temp. Auto
Mode Temp. Fan
Main Main menu
Restriction
Energy saving
Night setback
Filter information
Error information
Main display:
Cursor Page
F1 F2 F3 F4
Filter information
Please clean the filter.
Press Reset button after
filter cleaning.
Main menu:
Reset
F1 F2 F3 F4
Filter information
Reset filter sign?
Cancel OK
F1 F2 F3 F4
Filter information
Filter sign reset
Main menu:
10
will appear on the Main display
in the Full mode when it is time to
clean the fi lters.
Wash, clean, or replace the fi lters
when this sign appears.
Refer to the indoor unit Instruc-
tions Manual for details.
Select "Filter information" from the
Main menu (refer to page 7), and
press the [SELECT] button.
Press the [F4] button to reset fi lter
sign.
Refer to the indoor unit Instructions
Manual for how to clean the fi lter.
Select "OK" with the [F4] button.
A confi rmation screen will appear.
Navigating through the screens
• To go back to the Main menu
....................... [MENU] button
• To return to the previous screen
....................... [RETURN] button
Note: (for wireless remote controller)
Running the ventilator independently is not available.
●
No indication on the remote controller.
●
Fri
Room
Cool Set temp. Auto
Mode Temp. Fan
If two or more indoor units are connected, filter cleaning timing for
each unit may be different, depending on the fi lter type.
The icon will appear when the fi lter on the main unit is due for
cleaning.
When the fi lter sign is reset, the cumulative operation time of all units
will be reset.
The icon is scheduled to appear after a certain duration of op-
eration, based on the premise that the indoor units are installed in a
space with ordinary air quality. Depending on the air quality, the fi lter
may require more frequent cleaning.
The cumulative time at which filter needs cleaning depends on the
model.
• This indication is not available for wireless remote controller.
► Cleaning the filters
• Clean the fi lters using a vacuum cleaner. If you do not have a vacuum cleaner,
tap the fi lters against a solid object to knock off dirt and dust.
• If the fi lters are especially dirty, wash them in lukewarm water. Take care to rinse
off any detergent thoroughly and allow the fi lters to dry completely before putting
them back into the unit.
Caution:
• Do not dry the fi lters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the fi lters in hot water (above 50°C), as this may warp
them.
• Make sure that the air fi lters are always installed. Operating the unit
without air fi lters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with fi lters to remove the dust of sucked-
in air. Clean the fi lters using the methods shown in the following
sketches.
When the is displayed on the
Main display in the Full mode, the
system is centrally controlled and
the fi lter sign cannot be reset.