Advertisement
2. Refer to equipment manufacturer's
instructions for torque value.
3. Clean the fastener's threads. Dirty threads
may result in a misleading torque reading.
4. Select socket that properly fits the fastener.
Press socket firmly onto Square Drive.
5. Loosen the Lock Knob by turning it
counterclockwise until it stops.
6. To set torque value to 76:
a. Turn the Knurled Handle until top of handle
lines up with bottom horizontal mark
for 70 and 0 lines up with center line.
4
b. Turn Knurled Handle until the 6 lines
up with the center line. The torque
value is set to 76 in.-lb. (70 + 6 = 76)
0
Item 00239
FOOT POUNDS
150
140
130
120
110
100
90
80
70
6
2
0 8
FOOT POUNDS
150
140
130
120
110
100
90
80
70
2
8
6 4
For technical questions, please call 1-888-866-5797.
7. Tighten the Lock Knob by turning
it clockwise until it stops.
CAUTION: To prevent damage to the Torque
Wrench, do not use for loosening fasteners.
8. Set Switch to ON position. The
Torque Wrench can only measure
torque during clockwise operation.
Note: Thread fastener with another
tool until it is snug, then finish the
operation with the Torque Wrench.
9. Place socket on fastener, then grasp the
Knurled Handle and pull smoothly and
slowly until the handle breaks away and
a click is heard or felt. STOP PULLING!
The proper torque has been achieved.
Further pulling may damage fastener.
10. Release pressure to allow the handle
to reset for the next operation.
11. AFTER EVERY USE, loosen the Lock
Knob, set to the lowest torque setting,
then tighten the Lock Knob.
12. Store Wrench inside its case,
indoors, in a clean, dry location
that is out of reach of children.
On
Position
Page 3
Advertisement
