Stop Machine; After Work - Minuteman E Ride ER28C User Manual

First Operation
The battery/ fault gauge will
flash to signal that the machine
is almost out of power. When
this signal is displayed, all
functions will shut off (brushes
will turn off, the scrub deck and
vacuum shoe will raise. The
key switch must be turned OFF
then ON to reset the machine.
The machine will then only
have a few minutes left of re-
serve power for a short vacu-
um only mode to pick up re-
maining solution on the floor
and transport power to drive to
the battery recharging station.
If the machine is operated for
an excessive period of time af-
ter cleaning functions have
stopped, it will eventually turn
itself off. The machine will have
to be pushed back to the re-
charging station.
34
2.6

Stop Machine

To stop cleaning, select the transport
mode. This will automatically stop the
solution flow, raise the scrubdeck, and
turn off the vacuum motor (20-second
delay).
2.7

After Work

Refer to the "Maintenance" section for
specific maintenance instructions de-
scribed below.
1. When finished cleaning, select the
transport mode, all cleaning func-
tions will shut off. Move the machine
to a suitable site for maintenance.
2. Empty and clean the solution tank
3. Empty and clean the recovery tank
Observe the legal directives
and local regulations for dis-
posal of detergents.
4. Remove and clean the vac shoes.
5. Check operating fluid levels, function
and setting.
6. Clean the machine.
Do not clean the electrical
parts by means of high-pres-
sure cleaning equipment.
7. Check the maintenance schedule
and perform any required mainte-
nance before storing the machine.
8. Charge batteries.
9. Store the machine indoors in a clean
dry place.
Keep from freezing
Leave the solution and recov-
ery tank lids open for ventila-
tion to prevent odor build-up.
10.Turn key switch OFF and remove
key.
Remove the key to avoid unau-
thorized use of the machine.