Download Print this page

Seat Adjustment; Head Support Adjustment - Infantino Unison series Owner's Manual

Advertisement

Pick up your baby and place him or her on your
7.
chest, facing towards you.
Holding baby in your right arm, use your left hand
to place his or her leg through the Leg Opening
on your left side.
Switch your support of baby to your left arm. With
your right hand, place his or her leg through the
Leg Opening on your right side.
NOTE: If you prefer to start with your left arm supporting baby,
simply swap left for right, and vice versa, in these instructions.
Bring the Carrier Body up over your baby. Make
8.
sure one arm is securely supporting baby throughout
the buckling process. Baby is not secure until all
the buckles and straps are properly fastened and
adjusted.
Supporting baby with your left arm, fasten the
Shoulder Buckle on your right shoulder. You will
hear a "click" when the buckle is secure.
Switch your support of baby to your right arm, and
fasten the Shoulder Buckle on your left shoulder.
You will hear a "click" when the buckle is secure.
NOTE: If you prefer to start with your right arm supporting baby,
simply swap left for right, and vice versa, in these instructions.
9.
While still supporting baby, pull the Torso Band
Strap behind you to tighten the band and pull baby
close in to your body. Make sure the Torso Band is
snug, but not too tight. Baby's legs should not be
constricted.
IMPORTANT: Always make sure baby's face, nose, and mouth
are not obstructed.
Check your baby's position regularly. Your baby should be
centered in the carrier in a seated position with arms and legs
extended and not constricted by the carrier. It is extremely
important to avoid any slouching in baby's position. A slouching
position can restrict baby's airways.
Baby's head should be upright or resting on your chest with
the face, nose, and mouth positioned to the left or right. Baby's
chin should never rest on baby's chest. This can result in
closing or partially closing baby's airway.
7.
10.
1.
W hen the baby is properly positioned, you should be
able to tilt your head forward and kiss the top of your
baby's head.
To adjust the baby higher on your chest, lift the baby
slightly and pull the Shoulder Strap End tighter, first
on one side, then on the other.

Seat Adjustment

1.
The carrier seat adjusts to fit your baby's size. Your
baby should be in a seated position with his or her
legs supported from knee-to-knee.
For a small baby, the Body Side Panels should be
gathered inward for a narrow seat. The panels should
support your baby from knee-to-knee.
For an older baby, spread the Body Side Panels out
under baby's thighs. The panels should support your
baby from knee-to-knee.

Head Support Adjustment

1.
If your baby can fully hold his or her head upright on
their own, you can lower the Head Support. Your
baby MUST have sufficient head control before you
lower the Head Support.
Open the Head Support Buttons on both sides, and
fold down the Head Support in front of you. Secure
the Head Support to the Carrier Body by fastening
the Head Support Snaps.
8.

Advertisement

loading