Epson RC180 Safety And Installation page 69

Installation
- Mount the Controller mounting screws with 80 to 110 Ncm torque.
- Install the controller on a flat surface such as wall, floor, and controller box in the
direction shown from (A) to (D).
(A)
(C)
There are two types of fixtures. Mount the fixture to the Controller with the four
attached screws.
The length from the edge of fixture L differs by the side. Refer to the following
NOTE
figure and mount the side with shorter distance from the edge to the screw hole on
the Upper side.
RC180 Safety and Installation Rev.18
Base Table
Fixture L: Used in (A), (B), and (D) / Fixture S: Used in (C)
(B)
Fixture L
(D)
Fixture S
2. Installation
Base Table
Fixture L
Rack
Fixture L
Base Table
55