Scheduling; About Scheduling; Creating Schedules - Honeywell VISTA-20P User Manual

About Scheduling

The system provides end-user schedules (programmable by master/installer only),
which can control various types of events.
• Each schedule causes a defined event to start and stop (when appropriate) at a
specified time.
• Schedules can be set to automatically repeat at various intervals.
• Schedules can be set for random starting, if desired.
• VISTA-20P Series provides up to 16 user schedules.
• VISTA-15P Series provides up to 4 user schedules.

Creating Schedules

1.
(Master Code)
2. Enter a 2-digit schedule number from:
01-16 (VISTA-20P Series) or 01-04 (VISTA-15P Series)
Press [∗] to continue.
3. Enter the desired 2-digit event number from the list:
00 = clear the scheduled event
01 = turn a programmed output on or off
(see Using Device Commands section for a list of output device numbers
used in your system)
02 = set a user access schedule for one or more users
(see Security Codes section for an explanation of access groups)
03 = send a "latch-key" report to a pager if the system is not disarmed by a
specified time; message sent is "777-7777."
04 = automatically arm the system in STAY mode at a specified time
05 = automatically arm the system in AWAY mode at a specified time
06 = automatically disarm the system at a specified time
07 = Display the word "REMINDER" at a specified time (if selected, the keypad
beeps every 30 seconds beginning when the word "REMINDER" is first
displayed, and the display alternates with the normal keypad display about
every 4-5 seconds. To stop the beeps and cancel the display once it starts,
press any key).
Press [∗] to continue.
4. For event number "01," enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.
Press [∗] to continue to the "Start" prompt.
+ [#] + [6] [4]
National Security Systems (800) 457-1999

Scheduling

Alpha Displays:
1 DISARMED
READY TO ARM
ENTER SCHED NO.
00=QUIT 00
ENTER EVENT
CLEAR EVENT 00
RELAY NUMBER
00
– 37 –