Bosch Lave-Vaisselle Operating Instructions Manual page 19

Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "b:02".
4 Press the "C" button to increase or decrease the tone "b:00" = OFF
and "b:03" = LOUDEST and press [Start] to save setting and close the
door.
Setting the Amount of Rinse Aid Used
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "r:05".
4 Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
5 Press [Start] to save the setting and close the door.
Note: Using rinse aid and setting the dispenser to "r:00" may result in longer cy-
cle times.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. This setting can be adjusted from P:00 to P:02.
To change the setting:
1
Open the door and
2 Hold down the "A" button (see page 17)and press [Start] until the
display indicates "d:0x" (x can be any number). Release both but-
tons.
3 Press the "A" button until the display indicates "P:0x".
4 Press the "C" button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5
Press [Start] to save the setting
press the [On/Off] button.
.
17