Download  Print this page

Kawasaki KZ500 Manual Page 287

1979-1985.
Hide thumbs

Advertisement

Table of Contents
1982 AND LATER SERVICE INFORMATION
277
STARTER SYSTEM
Main switch
(2x550-A1 AND A2)
Starter
circuit
-
relay
-
Fuse
3
*
-
/\
L -
f \
f \
A
Start
Starter
relay
Battery
lockout
switch
- -
STARTING SYSTEM
(ZX550-A1 AND A2)
The starting system for the ZX550-A1 and
A2 models is shown in Figure 50; refer to it
when performing the procedures in this
section.
Starter Relay Testing
1. Remove the left-hand side cover.
2. Disconnect the starter relay connector
(Figure 51).
3. With a voltmeter set at DC, connect the
positive
(+)
lead to the black starter relay
circuit wire and the negative lead
(-)
to the
black/yellow wire.
4. With the ignition switch ON and the
transmission in NEUTRAL, push the starter
switch and observe the voltmeter. It should
read approximately 12 volts.
5. If the voltage is incorrect in Step 4, check
the main fuse and all starting system wires
and connections. Also check the engine stop
switch, ignition switch, neutral switch and the
Property of www.SmallEngineDiscount.com - Not for Resale

Advertisement

Table of Contents

   Also See for Kawasaki KZ500

This manual is also suitable for:

Zx550Kz550Kzx550

Comments to this Manuals

Symbols: 0
Latest comments: