Download  Print this page

Advertisement

Table of Contents
272
SUPPLEMENT
CARBURETOR
(KZ550mF1 AND M I )
1. Screw
2. Cover
3. Spring
4. Stop
5. Clip
6. Jet needle
7. Vacuum slide and diaphragm assembly
8. Plug (U.S. models only)
9. Pilot screw
10. O-ring
11. Spring
12. Starter plunger
13. Plunger cap
14. Dust seal
15. Pilot jet
16. Needle jet
17. Bleed pipe (prim
18. Main jet
19. Filter
20. O-ring
21. Valve seat
22. Valve needle
23. Float pin
24. Float
25. O-ring
26. O-ring
27. Float bowl
28. O-ring
29. Drain plug
3. Remove the screws securing the mounting
plates to the carburetors and remove the
plates.
4. Separate the 4 carburetors.
5. To assemble, reverse these steps. Note the
following:
a. The centerlines of the carburetor bores
must be parallel both vertically and
horizontally. If necessary, loosen the
mounting
plate
screws, place the
carburetor assembly on a flat surface,
align the bores and tighten the screws.
b. To install the choke shaft, grease the
shaft positioning spring and ball and
insert them into the No.
3
lever. Lightly
grease the choke shaft hole in the
Property of www.SmallEngineDiscount.com - Not for Resale

Advertisement

Table of Contents

   Also See for Kawasaki KZ500

This manual is also suitable for:

Zx550Kz550Kzx550

Comments to this Manuals

Symbols: 0
Latest comments: