1. Cotter pin
10. Sprocket bolt (6)
2. Axle nut
11. Sprocket locknut (6)
4. Rear sprocket
13. Rubber damper
5. Grease seal
14. Rear wheel
7. Ball bearing
16. Brake assembly
8. Wheel coupler
9. Coupler sleeve
may require caliper disassembly and
a. Inspect the wheel coupling damper (A.
brake system bleeding.
Figure 12) and install a new one if worn.
7. To disassemble the wheel hub, see Figure 14
the hub O-ring and grease it (B,
and refer to Wheel Bearings and Seals in this
chapter. When installing a brake disc, face the
c. Clean any oil or dirt from the brake disc
marked side out and torque the brake disc
with a non-oily solvent.
mounting bolts as specified in Table 4.
d. Adjust drive chain play, brake pedal play.
To install, reverse the removal steps. Note
and rear brake light switch operation as
described in Chapter Three.
Property of www.SmallEngineDiscount.com - Not for Resale