Ifthe cable won't seat easily, slowly turn
the wheel until the cable end aligns with
d. Torque the axle nut, then the pinch nut as
specified in Table
e. Clean any oil or dirt from the brake disc
with a non-oily solvent.
Install the brake caliper and torque the
caliper mounting bolts as specified in
g. After the wheel is installed, spin it to
make sure it turns freely and apply the
brake several times to make sure the pads
are seated against the disc.
On models with no external tabs
speedometer drive (Figure
drive gears at the front wheel should be
lubricated with high-temperature grease
according to the maintenance schedule (Table
1) in Chapter Three.
1 . Remove the front wheel from the
2. Clean all old grease from the gear housing
and gear, and pack the gearbox with
Install the front wheel on the motorcycle.
Property of www.SmallEngineDiscount.com - Not for Resale