WHEELS, TIRES A N D BRAKES
out and torque the brake disc mounting bolts as
specified in Table 4.
7. To install, reverse the removal steps. Note
a. On models with no external tabs on the
speedometer drive, the hub driver notches
(Figure 7) must mate with the internal
tabs in the speedometer drive.
b. On models with external tabs on the
speedometer drive, the tabs must fit in the
Make sure the speedometer drive tabs
are correctly seated in both the wheel hub
and in the speedometer drive gearbox
before you tighten the axle nut or you
may damage the drive.
c. Do not tighten the axle nut until after the
speedometer cable is connected to the
gearbox. Tighten the cable nut with
hub notches (Figure 8).
1. Axle nut
2. Speedometer drive body
3. Speedometer gear
4. Grease seal
11. Speedometer drive
12. Ball bearing
14. Left disc
16. Right disc (dual disc models)
17. Disc bolt (7 each)
18. Cover (single disc models)
19. Washer (2; single disc models)
20. Screw (2; single disc models)
Property of www.SmallEngineDiscount.com - Not for Resale