Download  Print this page

Advertisement

Table of Contents
ELECTRICAL SYSTEMS
187
rim (Figure 44). On the KZ550-D, the screw is
on the left side of the headlight rim.
NOTE
On models ~rnported rnto the Llnrted
Krngdor??, rherc rs no horizontal
adjustmwt.
Vertical adjustment
(KZSOO, KZ550-A)
For vertical a d j u s t m e n t , just tilt the
headlight assembly up or down as required.
XOTE
I f the headlrght 1s roo t~ght to mow,
relnovc the headlrght assernhlj* and
looyen the headlrght shell rnountlng
nuts.
Vertical adjustment
(KZ5.50-C, D)
Remove the fairing from the KZ550-D: see
Fairing Rerno~'al
in Chapter Ten. Loosen the
bottom positioning bolt under the headlight
and tilt the headlight as required. Tighten the
positioning bolt. Install the fairing.
NOTE
I f the headlight is too tight to move,
rcrnove the headlrght assetnhly and
loosen the headlzght shell tnountlng
nuts.
Headlight Replacement
(Quartz Halogen Models, Except KZSSO-D)
I. Remove the mounting screw (Figure 45) on
each side of the headlight housing.
2. Swing the trim bezel and headlight unit out
and remove the electrical connector from the
backside.
3.
Remove the dust cover from the back ofthe
light housing, squeeze the spring clip (Figure
46) and remove the lighting element, Install a
new element.
CA
UTION
Use a clean cloth to grasp the quart:
bulb. Don't handle a quartz bulb with
sour bare.fingers or a dirty rag. They'll
leave oil on the b d b and will cause it to
burn out early.
4. Adjust the headlight as described under
Headlight Adjustment
in this chapter.
Property of www.SmallEngineDiscount.com - Not for Resale

Advertisement

Table of Contents

   Also See for Kawasaki KZ500

This manual is also suitable for:

Zx550Kz550Kzx550

Comments to this Manuals

Symbols: 0
Latest comments: