FUEL AND EXHAUST SYSTEMS
maintenance other than to make sure the
connecting clamps are tight.
1. See Figure 48. Loosen the crossover pipe
clamps (Figure 49).
2. Remove the rear footpeg mounting bolts
Remove the exhaust pipe holder nuts
(Figure 51) and pry the holders free from the
4. Pull the exhaust pipe and muffler
assemblies out ofthe cylinder head and remove
the split collars (Figure
T o separate the exhaust pipe from the
muffler, loosen the clamp bolt and twist the
mumer off of the pipe.
6. T o install, reverse the removal steps. Note
a. Make sure the gaskets at the pipehumer
joint and at the crossover pipe are in good
b. Use new gaskets in the cylinder head
exhaust ports (Figure 53).
Property of www.SmallEngineDiscount.com - Not for Resale