D-Link DCH-G020 User Manual page 14

DCH-G020
Z-Wave Node Page
This page allows the user to do the advanced Z-Wave configuration of other Z-
Wave sensors.
(Please refresh the GUI to show up the newest status)
: To remove the failed node.
: To replace the failed node.
: Send the BASIC SET ON command to switch the node ON.
: Send the BASIC SET OFF command to switch the node OFF.
: Send the BASIC GET command to the selected node.
: (Security) Node 2 is included by DCH-G020 with security
: (Non-Security) Node 3 is included by DCH-G020 without security
Additional Notes:
1. The Z-Wave Grouping Identifier of DCH-G020 is 1 and used for the Lifeline
association.
2. The maximum number of devices that can be added to the group is 1.
Data Sheet Page 14
D-Link Corporation
2/11/2015