Installation - Valor PORTRAIT 575LFK Installation Instructions Manual

Tip
In steps 4, 5 and 7 in the following instructions,
assemble the parts loosely, just enough for them
to hold together. This will allow you to fi t all the
parts more easily. Then, in step 10, after all the
parts are fi tted together and adjusted, tighten all
the screws.

Installation

1. Identify the front and rear of one cast iron/concrete
side panel. The front of the panel has a protruding
piece at the top.
2. Install the bottom support brackets. Loosen off the
bottom screws and insert the screw heads in the
keyholes of the brackets as shown. Make sure the
brackets are oriented properly. Tighten the screws.
front
Bottom brackets orientation
outer edge with
two holes
inner edge with
downward lip
4
Rear view
Rear view
3. On the other side panel, loosen off the bottom
screws. Place the fi rst panel at the desired location.
Place the second panel as indicated and attach
the bottom support brackets sliding them over the
screw heads of the panel. Tighten the screws.
4. Loosely fi x the front hanging bracket to the side
panels with one black machine screw on each side.
Top
Bottom
Lip goes
to the front
Front view, left side
Front view
Front view
Rear view