Mount The Camera - D-Link DCS-2630L Quick Install Manual

Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
1. Rotate the camera base cover counterclockwise, then lift
it to expose the mounting holes.
2. Place the camera base where you want to position the
camera and use a pencil to mark the holes.
3. Depending on the material of the wall or ceiling, use
proper tools to drill four holes 25mm deep with a
6mm drill bit where you marked. If the wall is made
out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
4. Place the camera base over the holes that are in the
wall. Make sure to align the camera base holes with the
holes in the wall. Use the supplied screws to attach the
camera to the surface of the wall.
Do not overtighten the screws as this may
crack the mount.
5. Attach the base cover and turn it clockwise to lock it
in place.
6. Adjust the angle of the camera as desired and then
attached the power supply to the camera and plug
into a power outlet.

Mount the Camera

5
1
2
3
4
5
6