Table of Contents
Advertisement
Registering and de-registering
handsets
You can register up to four handsets on your base
station.
A Gigaset A14handset that is not yet registered on
a base is registered automatically. Other handsets
must be registered manually.
Automatic registering:
Gigaset handset A14
Any Gigaset A14handset that is not registered to a
base can be registered automatically. To register a
handset for the first time, place it in the base with
the display facing forward. Registering takes
about 1 minute; a number of icons flash in the dis-
play. The handset is automatically assigned the
next available internal number (1–4). This number
appears in the top left of the display after success-
ful registering, e.g. "2". If all of the internal num-
bers 1 to 4 are used up (i.e. four handsets have
been registered), handset number 4 is de-regis-
tered and overwritten.
Manual registering:
Gigaset handset A14
1. On the handset:
MENU
enter your system PIN (default is 0000)
The display shows
REGISTER HS
tration procedure.
2. On the base: Within 60 sec. of entering the sys-
tem PIN, press the register/paging key on the front
of the base (page 1) and hold for approx. 3 sec.
The registration process starts.
Manual registering: Other handsets
Other handsets are registered as follows:
1. On the handset: Start to register your handset
as described in its operating instructions.
2. On the base: Press the register/paging key on
the front of the base (page 1) for approx. 3 sec.
The registration process starts.
De-registering handsets
You can de-register another handset from any reg-
istered Gigaset A14handset as follows:
¢
Select handset
INT
¢
DE-REG H/SET
OK
Enter the system PIN (default is 0000)
¢
DE-REGISTER?
OK
The internal number disappears from the de-regis-
tered handset. Handsets that have not been de-
registered retain their internal number.
¢
REGISTER HS
¢
OK
during the regis-
¢
¢
MENU
¢
¢
OK
¢
a
.
5
Using several handsets
Internal calls
Internal calls are no-cost calls to other handsets
that are registered to the same base.
INT
either ...
~
or ...
P
... then
a
Internal conference/Call connecting
You are in conversation with an external caller.
To confer:
(the external party hears the wait melody)
INT
Select a handset
¢
party).
¢
End:
MENU
.
You are reconnected with the external caller.
Or to connect the call:
¢
Select a handset
INT
call if required)
You can also press the end call key
ately (without announcing the call). If the internal
party does not answer or is busy the call will come
back to you automatically.
¢
Press the display key.
Your own handset is marked "<".
Call a single handset:
Enter number of handset,
2
e.g.
.
Calling all handsets:
Press the star key.
Ending the call:
Press the end call key.
¢
c
(confer with internal
¢
GO BACK
OK.
¢
c
(announce the
¢
a
Press the end call key.
a
¢
immedi-
Advertisement
Table of Contents
