Control Features - GE GDWT668V Technical Service Manual

Throughout this manual, features and appearance may vary from your model.
Top-Control Dishwashers
3
Control Settings
1
Status Indicator Lights
The Status display tells you what is happening while the dishwasher is in operation and may flash, indicating
a malfunction. The lights will come ON indicating the sequence of the dishwasher operation.
LOW DETERGENT Displayed when the SmartDispense
CYCLE STATUS The cycle status indicator light is located on the right side of the dishwasher, above the
2
Time Remaining Display
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
NOTE: This dishwasher is equipped with CleanSensor
cycle length and time may vary depending on soil and water temperature conditions.
6

Control Features

1
6
(Indicators vary by models)
dishwasher detergent.
NOTE: If you are not using SmartDispense
LED light off, press the ADDED HEAT button 5 times within 3 seconds. You will hear 3
beeps; then the light will go off. You can turn the light back on by pressing the ADDED
HEAT button 5 times within 3 seconds.
SENSING Displayed while the Clean Sensor
of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
SANITIZED Displayed at the end of the cycle when SANITIZE has been selected and the dishwasher
has met the requirements for sanitization. See SANITIZE, below, for complete cycle
description. Opening the door or pressing any key while the door is closed and latched
will turn off the light.
CLEAN Displayed when a wash cycle is complete. Refer to Item 6, page 9, for further
explanation of clean light operation
INDICATOR handle. This light comes on as amber while the selected cycle is running. The light turns
to green when the selected cycle is complete. The light stays ON as green as a reminder
that the dishes are clean until the door is opened or until another cycle is selected.
(on some models)
2
4
needs to be refilled with liquid or gel automatic
TM
and you want to turn the LOW DETERGENT
TM
is measuring the amount of soil and temperature
TM
with automatic temperature control; therefore,
TM
– 7 –
5
Cycle Status Indicator Light
(Continued next page)