Re-Assembling The Freezer Door; Making Minor Adjustments To The Doors; Adjusting The Level - Samsung RF28HM Series User Manual

RE-ASSEMBLING THE
FREEZER DOOR
To reattach the drawer after you have moved
the fridge to its fi nal location, assemble the parts
in reverse order.

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can
make fi nal adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, you will not
be able to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into the
notch on the left control lever, and then turn
it counter-clockwise to level the refrigerator.
(You turn the lever clockwise to lower the
refrigerator and counterclockwise to raise it.)
flat-blade flat-blade
screwdriver (-) screwdriver (-)
DA68-02952A-01.indb 14 DA68-02952A-01.indb 14
Control Lever Control Lever
English - 14
CAUTION
Both control levers must be touching the fl oor to
avoid possible personal injury or property damage
because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
MAKING MINOR
ADJUSTMENTS TO THE
DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Fixed part Fixed part
The left door is fixed. To make minor
adjustments between doors, adjust only
the right door.
1. Pull out the Convertible door ( 1 ) to expose
the lower hinge ( 2 ).
2. Insert the supplied allen wrench (5/32" (4 mm))
( 3 ) into the shaft ( 4 ) of the lower hinge.
3. Please adjust the height by turning the hex
wrench ( 3 ) clockwise (
UP UP
clockwise ( ).
Adjustment Adjustment
part part
DOWN DOWN
) or counter-
2013. 12. 3. 2013. 12. 3. 8:50 8:50