Test Mode - Sony STR-DH510 Service Manual

STR-DH510
QQ
3 7 63 1515 0
AM CHANNEL STEP 9 kHz/10 kHz SELECTION MODE
(US, Canadian model only)
* Either the 9 kHz step or 10 kHz step can be selected for the AM
channel step.
* Procedure:
Turn the [INPUT SELECTOR] control to set AM and press the
[ ] button to turn off the main power.
?/1
1. While depressing the [TUNING MODE] button, press the
[ ] button to turn on the main power.
?/1
2. Either the message "9K STEP" or "10K STEP" appears for a
moment and select the desired step.
VACUUM FLUORESCENT DISPLAY TEST MODE
* All fluorescent segments are tested.
When this test is activated, all segments light on at the same time,
then each segment lights on one after another.
* Procedure:
While depressing the [TUNING +] and the [DIMMER] buttons
simultaneously, press the [
?/1
er.
1. ALL segments light on.
LFE HDMI DTS -ES
LH RH SW
COAX OPT DTS-HD
L C R
SL S SR
SBL SB SBR
2. Press the [DISPLAY] button, confirm display.
LFE HDMI DTS -ES
LH RH SW
TE
COAX OPT DTS-HD
L 13942296513
L C R
SL S SR
SBL SB SBR
3. Press the [DISPLAY] button, confirm display.
LFE HDMI DTS -ES
LH RH SW
COAX OPT DTS-HD
L C R
SL S SR
SBL SB SBR
4. Press the [DISPLAY] button, all segments light off.
SOUND FIELD CLEAR MODE
* The preset sound field is cleared when this mode is activated.
Use this mode before returning the product to clients upon com-
pletion of repair.
* Procedure:
1. While depressing the [MUSIC] button, press the [
to turn on the main power.
2. The message "S.F. CLEAR" appears for a moment and initial-
ization is performed.
SOFTWARE VERSION CHECK MODE
* The software version is displayed.
* Procedure:
1. While depressing the [TUNING MODE] and the [DISPLAY]
www
buttons simultaneously, press the [
main power.
2. The model name, destination and the software version are
displayed for a moment. .
8
http://www.xiaoyu163.com
SECTION 2

TEST MODE

] button to turn on the main pow-
NEO:6 S-AIR PL II x z
96/24 TrueHD
D + EX SLEEP
MSTR HI RES LBR LPCM
AAC ST D.RANGE
dB RDS
k Hz m
ft.
MHz
96/24 NEO:6 S-AIR PL II x z TrueHD
D + EX SLEEP
MSTR HI RES LBR LPCM
AAC ST
D.RANGE
dB RDS
k Hz m
ft.
MHz
96/24 NEO:6 S-AIR PL II x z TrueHD
D + EX SLEEP
MSTR HI RES LBR LPCM
AAC ST D.RANGE
dB RDS
k Hz m
ft.
MHz
] button
?/1
] button to turn on the
?/1
x ao
y
i
http://www.xiaoyu163.com
8
KEY CHECK MODE
* Button check
* Procedure:
1. While depressing the [TUNING +] and the [MUTING] but-
tons simultaneously, press the [
power.
2. The message "REST 12" appears.
3. Every pressing of any button other than the [
the buttons. The buttons which are already counted once are
not counted again. When all buttons are pressed "REST 00"
appears.
SWAP ALL MODE
* The signal will be swap to all channel so that all speaker will
have sound output.
* Procedure:
1. While depressing the [TUNING MODE] and the [MOVIE]
buttons simultaneously, press the power [
on the main power.
2. "SWAP.MODE" appears. (No change while displayed.)
SHIPMENT MODE
* All preset contents are reset to the default setting.
* Procedure:
1. While depressing the [TUNING MODE] and the [DIMMER]
buttons simultaneously, press the power [
on the main power.
2. The message "CLEARING" appears.
3. After a few seconds, "CLEARED" appears and switch off the
set.
Q Q
PROTECTOR AUTO OFF
3 6 7 1 3
* To disable auto off after protector occur.
* Procedure:
1. While depressing the [INPUT MODE] and the [A.F.D.] but-
tons simultaneously, press the power [
the main power.
2. "PROTECT" appears.
u163
.
2 9 9 4 2 8
] button to turn on the main
?/1
] counts down
?/1
] button to turn
?/1
] button to turn
?/1
1 5 0 5 8 2 9 9 4
] button to turn on
?/1
m
co
9 9
2 8 9 9