Panasonic CF-M34 Operating Instructions Manual page 15

Usage Example
3
Log on to Windows
Windows 2000
Wait for 10 seconds after confirming that the hard disk drive access has been com-
pleted, input the user name and password, then select [OK]. Until the correct user
name and password are entered, the computer will not operate.
Windows XP
Wait for 10 seconds after confirming that the hard disk access has been completed,
select the user and input the password, then select
entered the computer will not operate.
4
Select your application
You are able to start working on your computer.
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad, touchscreen or an external mouse (when one is connected) for a certain interval
of time, the power to the LCD and hard disk may be turned off. The LCD will
resume operation when the touch pad, touchscreen or an external mouse (when one
is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable that
a selection dialog box will be shown, do not press Space or Enter to attempt
to resume from this condition as doing so may trigger a selection, but instead, press
a key unrelated to the direct triggering of a selection, like
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode (
will resume by sliding the power switch.
Windows 2000
When a new device has been installed or a new Windows Component has been
added in [Start] - [Settings] - [Control Panel] - [Add/Remove Programs], [Insert
Disk] may appear. Select [OK] and specify [c:\winnt\cdimage] in place of
[c:\sysprep\i386] or [D:], then select [OK].
e.g. [c:\winnt\cdimage\i386] in place of [D:\i386]
Windows XP
When you create the first new account, you can only select [computer administrator].
Only the added user account will be displayed in the Welcome screen. The account
for the administrator created during Windows setup (when the computer is started
up for the first time) will not be displayed.
When switching to a different user with the Fast User Switching function, it may not
be possible to set the settings of the display. In this case, log on with the administra-
tor authority again, not using the Fast User Switching function, and try the operation
once more.
The hand strap is convenient for computing while standing.
Adjust the length of the belt so that the computer does not fall by mistake, and firmly hold the
computer when using it.
CAUTION
Do not add a lot of weight to the hand strap.
The hand strap may accidentally come loose from the computer.
. Until the correct password
"Standby/Hibernation Functions"). The computer
Ctrl
.
15