Operation - Panasonic CF-M34 Operating Instructions Manual

7
Select the Operating System
Windows 2000 and Windows XP are preinstalled on this computer. After one of them
is selected with the following procedure, only that Operating System can be used.
At the screen for the agreement of the selection of the Operating System, select [Y].
1
With the number keys, select either Windows 2000 or Windows XP.
2
(The selection of the Operating System is only performed the first time the com-
puter is started up. A change cannot be made after the selection.)
At the confirmation message, select [Y]. The Operating System preparation will
3
start, during which the computer will restart.
CAUTION
Do not touch the keyboard. If you accidentally touch the keyboard and the
cancel confirmation menu is displayed, do not cancel.
When the screen indicating the completion of the Operating System preparation
4
is displayed, press any key.
The computer will restart.
8
Setup Windows
Moving the cursor ( ) or clicking buttons can be performed with the touch pad.
Windows 2000
CAUTION
Do not press any key or move the touch pad until [Windows 2000 Profes-
sional Setup] is displayed.
NOTE
For models with wireless LAN (CF-WWL341)
It is not necessary to carry out
in the Supplementary Instructions for wireless LAN.
At the [Welcome to the Windows 2000 Setup Wizard], select [Next].
1
After reading the agreement, select [I accept this agreement] or [I don't accept
2
this agreement], then select [Next].
NOTE
If [I don't accept this agreement] is selected, the Windows setup will be aborted.
Select settings for your region, then select [Next].
3
Enter your name and organization and select [Next].
4
Enter your computer name and administrator password and select [Next].
5
CAUTION
Remember this password! If the password is forgotten, Windows 2000 can-
not be operated.
Enter the correct date, time and time zone and select [Next].
6
You can also complete these settings at a later time.
At the [Networking Settings], select [Typical settings], then select [Next].
7
At the [Workgroup or Computer Domain], select [No, this computer is not on a
8
network, or is on a network without a domain], then select [Next].
The computer will restart.
At the [Welcome to the Network Identification Wizard], select [Next].
9
At the [Users of This Computer], select [Users must enter a user name and pass-
10
word to use this computer], then select [Next].
Select [Finish].
11
Enter your administrator password and select [OK].
12
- in step 8 of "First-time Operation"
22 23
11