Safety Instructions For Installation - Miele KM 2010 Operating And Installation Instructions

Table of Contents

Advertisement

Safety instructions for installation

Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the surface.
~
The room in which the gas hob is
installed must be at least 20 m
with a door or window in it which can
be opened to the outside air.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This equipment may only be used in
mobile installations such as ships,
caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
~
An electric fryer must not be
installed directly next to a gas hob, as
the gas flames could ignite the fat in the
fryer. It is essential to maintain a
distance of at least 300 mm between
these two appliances.
32
~
A gas hob may not be built in over a
fridge, fridge freezer, freezer,
dishwasher, washing machine or
tumble dryer.
~
Ensure that the gas pipe and
electrical cable are installed in such a
3
in size
way that they do not touch any parts of
the appliance which become hot. This
could cause damage.
~
The electrical cable (and flexible
gas connection pipes in countries
where applicable) must be installed in
such a way so that they do not come
into contact with any moving kitchen
parts (e.g. a drawer), and cannot
become trapped.
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop (see "General installation tips").
All dimensions in this instruction booklet
are given in mm.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents