Assembly - Makita LS1018 Instruction Manual

Do not use solvents or any petroleum-based cleaners on
the lens.
NOTE:
When laser line is dim and almost or entirely
•
invisible because of the direct sunlight in the indoor
or outdoor window-by work, relocate the work area
to a place not exposed to the direct sunlight.

ASSEMBLY

WARNING:
Always be sure that the tool is switched off and
•
unplugged before working on the tool. Failure to
switch off and unplug the tool may result in serious
personal injury.
Storage of socket wrench with hex wrench on
its other end
011338
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out of
the wrench holder. After using the socket wrench it can
be stored by returning it to the wrench holder.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the
blade. Accidental start up of the tool may result in
serious personal injury.
Use only the Makita socket wrench provided to
•
install or remove the blade.Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
1
010477
1. Socket wrench
2
with hex wrench
on its other end
2. Wrench holder
1
1. Stopper pin
Lock the handle in the raised position by pushing in the
stopper pin.
1
010241
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1
2 3
010242
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
NOTE:
If the inner flange is removed be sure to install it on
•
the spindle with its protrusion facing away from the
blade. If the flange is installed incorrectly the
flange will rub against the machine.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the
blade's arbor hole you intend to use is installed
between the inner and the outer flanges. Use of
the incorrect arbor hole ring
improper mounting of the blade causing blade
movement and severe vibration resulting in
possible loss of control during operation and in
serious personal injury.
1
010244
10
1. Socket wrench
2
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Blade case
4
2. Socket wrench
5
3. Hex bolt
4. Arrow
5. Shaft lock
may result in the
1. Blade case
2
4
2. Arrow
3
3. Arrow
4. Saw blade