JRC JFC-7050 Operation Manual page 5

Installation Cautions <For service Personnel>
Follow installation instructions to avoid personal injury and system malfunction.
Installation in
rigid location.
Use correct
Installation
materials.
Keep away from
direct sunlight.
Keep away from
water.
Keep away from heat
source.
Use correct power
source.
Maintenance Cautions<For Maintenance Personnel>
Use the following safety precaution internal inspection.
Discharge capacitors.
Check that power is
OFF
Avoid EMI.
Avoid dust.
Mount your JFC-7050 on a rigid frame or base to prevent your unit from
working loose.
Use the installation materials provided in the standard accessory pack
only. If you use hardware of insufficient strength, your system may
loosen causing damaged.
Keep your system out of direct sunlight as it may become damaged by
overheating.
Take care not to get water on or in your unit as it may be damaged
and/or cause an electrical shock.
Keep your system away from other heat source as it may malfunction,
be damaged, or burn.
Operate your system within the specified power voltage. An incorrect
power supply may cause
High voltage may be retained in the capacitors if the high-tension
circuit several minutes after you have turned the power switch off.
To prevent an electrical injury due to erroneous power switching, make
sure that the main power supply and the system power switch are both
in the off position. Additionally, attach a safety label showing that
service is in progress.
Take care not to damage the ESDs (Electrostatic Sensitive Devices)
by static electricity from carpet and cloths.
Wear a safety mask so as not to breath in dust during inspection or
cleaning inside your system instruments.
- 2 -