Replacing The Pf Name Plate; Installing The Microsd Memory Card - Kenwood KCH-20R User Manual

You can reconfigure the PF name plates at
any time.
1 Remove the current PF name plate from
the function key using a fine-tipped tool.
2 Punch out the PF name plate card, and
insert the plate onto the relative function
key.
1 Open the Cap.
2 Insert the microSD memory card.
• Insert the microSD memory card with its
terminal side facing the same side as the
front of the panel.
• Insert the microSD memory card until it
clicks into place.
• To remove the microSD memory card,
push the card inwards once, then pull it out
straight.
Note:
◆ microSD memory cards (Class 2 or higher) and microSDHC memory cards (Class 2 or higher)
can be used.
◆ SDXC memory cards cannot be used.
◆ This transceiver is not guaranteed to operate with all microSD memory cards.
(Operations are confirmed on memory cards for the following brands: SanDisk, TOSHIBA and
Panasonic.)
◆ Use the microSD memory card within the allowable operating temperature.
◆ Do not remove the microSD memory card or turn off this transceiver while the microSD memory
card is being accessed.
◆ The waterproof performance is not guaranteed if the microSD memory card slot cap is not fit into
place.
◆ Make sure your hands are clean before opening the microSD memory card slot cap.
Compensation Disclaimer
Data stored on the microSD memory card may be altered or lost due to problems with this
transceiver. We do not accept liability in respect of the data stored on your microSD memory card,
failure to save the data properly, loss of data, and any direct or indirect damages.

REPLACING THE PF NAME PLATE

INSTALLING THE microSD MEMORY CARD

microSD
memory card
Cap
3
Name plate
Squeeze and insert
the plate