To Delime Water Reservoir/Internal Parts - Mr. Coffee ECMP50 Instruction Manual With Recipes

Espresso & cappuccino maker
Hide thumbs Also See for ECMP50:
Table of Contents

Advertisement

Available languages

Available languages

YOUR ESPRESSO/CAPPUCCINO MAkER
MAY BE DELIMED USING wHITE
HOUSEHOLD VINEGAR, AS FOLLOwS:
TO DELIME wATER RESERVOIR:
1. Make sure the side control knob is in the off position " ", the red switch is in the off
position "O" and that the power cord is disconnected from the electrical outlet.
2. Fill the reservoir with fresh, undiluted white household vinegar.
3. Allow appliance to sit overnight with the vinegar solution in the water reservoir.
4. Discard vinegar by removing the reservoir and turning it upside down over the sink.
5. Rinse the water reservoir thoroughly with tap water by filling tank half full with water
and then pouring the water back out into the sink, repeating this step twice.
TO DELIME INTERNAL PARTS:
1. Make sure you delime the inside of the water reservoir first by following the "Deliming"
steps above.
2. Make sure all controls are in the off position and the power cord is disconnected from
the electrical outlet and the appliance is. (See Section "CAUTION" on Page 4). Fill the
reservoir with white vinegar above the minimum level into reservoir.
3. Insert the brew basket (with filter) and place jar/carafe or regular cup on top of the drip
tray and under the brew basket.
4. Plug the power cord into the electrical outlet.
5. Press the red button to switch the unit on "I", once the ready light " " becomes solid
green, press the brew button "
brew position "
turn the side knob clockwise to the off position " ".
6. To clean the frothing tube internally, place a cup with cold water under the tip of the
frothing tube. Wait until the ready light "
tube into the water, press the steam button "
and once it becomes solid green again turn the side knob clockwise to the steam
position "
". Let the steam come out for about 10 seconds. This will clean any
residue left in the frothing tube from frothing milk.
7. Turn the side knob counter-clockwise to the off position " " and press the red switch to
the off position "O".
8. Repeat Steps 1 – 7 as necessary using only tap water to rinse any remaining traces of
vinegar out of the machine.
", turn the side control knob counter-clockwise to the
". The vinegar will start flowing through the unit. Once you are done,
" becomes solid green. Insert the frothing
". The ready light "

" will start blinking

Advertisement

Table of Contents
loading

Table of Contents