Names And Functions Of Indicators On Remote Control - Toshiba RAS-B13GKVP-E Owner's Manual

NAMES AND FUNCTIONS OF INDICATORS ON REMOTE
CONTROL
Display
All indicators, except for the clock time indicator, are displayed by pressing the
a Transmission mark
This transmission mark ( ) indicates when the remote control transmits signals to the indoor unit.
b Mode indicator
Indicates the current operation mode.
• Heat pump models
(AUTO: Automatic control, A: Auto changeover control,
: HEAT)
• Cooling-only models
(AUTO: Automatic control, A: Auto changeover control,
: FAN ONLY)
c Temperature indicator
Indicates the temperature setting (17°C to 30°C).
d PURE indicator
Shows that the electrical air purifying operation is in progress.
e FAN speed indicator
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW
LOW+ , MED
Indicates AUTO when the operating mode is either AUTO or
f TIMER and clock time indicator
The time setting for timer operation or the clock time is indicated.
The current time is always indicated except during TIMER operation.
g Hi POWER indicator
Indicates when Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop operation.
h (MEMORY) indicator
Flashes for 3 seconds when the MEMO button is pressed during operation.
The mark is shown when holding down the button for more than 3 seconds
while the mark is flashing.
Press another button to turn off the mark.
i ECO indicator
Indicates when the ECO is activated.
Press the ECO button to start and press it again to stop operation.
j A. B change indicator remote control
• When the remote control switching function is set, "B" appears in the remote
control display. (When the remote control setting is "A", there is no indication at this position.)
Remote control switching function
• If two indoor units are installed in the same room or adjoining rooms, both units may start and stop at the same time when
the remote control is operated. This can be prevented by setting the switching function so that each indoor unit is operated
only by the corresponding remote control.
• To use the remote control switching function, contact the air conditioner dealer or the installation company.
PREPARATION AND CHECK BEFORE USE
Loading the remote control batteries
a Remove the cover, and insert the batteries.
b Press the RESET button.
The clock time indicator flashes. Adjust the clock. Reattach the
cover.
, MED+ , HIGH
button.
c
: COOL, : DRY,
: COOL, : DRY,
i
• In the illustration, all indicators are shown
,
for purposes of explanation. During
) can be shown.
operation, only the relevant indicators are
: DRY.
shown on the remote control.
HiPOWER ECO
SWING FIX FAN
CLR
ON OFF
b
CLOCK
RESET
CHECK
5
b h j
a d
g e
MEMO
1 . 3 . 5 . 9H
SLEEP
SET
f
EN