Uv Sensor (Uvn128); Setup Sensor - Oregon Scientific BAR609HGA User Manual

WARNING HEAT INDEX
°F
Extreme 130 or
danger above
Danger 105-129
Extreme 90-104
caution
Caution 80-89
• To display the heat index, press HEAT INDEX.
• To toggle between current / maximum / minimum
readings, press HEAT INDEX, then press
CHANNEL to select channel 1-3 or indoor, followed
by MEMORY.
• To toggle between temperature / humidity and
heat index display, press and hold HEAT INDEX
for 2 seconds. Press HEAT INDEX again to stop
this feature.
NOTE If the heat index is below 80°F / 26°C, or the
desired channel is not working, the heat index will
display "NA".
MEANING
°C
54.5 or Strong
above possibility of
heat stroke
40.5-53.9 Heat
exhaustion
likely
32.2-40 Possibility
of heat
dehydration
26.6-31.7 Possibility
of heat
exhaustion

UV SENSOR (UVN128)

The UV sensor measures the UV Index. It transmits data
to the main unit every 73 seconds and has a maximum
transmission range of 328 feet (100 meters).
SET UP SENSOR
1. Insert the batteries as shown.
2. Close the battery door and press RESET to turn
the sensor on.
3. Press and hold CHANNEL and MEMORY on the
main unit to initiate a signal search. The UVI sensor
icon on the main unit will flash to show it is
searching for the sensor. It will stop flashing when
it has found the sensor. If the main unit cannot find
the sensor, "- -" will appear on the LCD.
12