Replacing The Secure Usb Compartment Cover - HP f10 Troubleshooting Manual

To remove the secure USB compartment cover:
1. Toward the rear of the thin client's compartment cover, remove the screw that secures the
compartment cover to the unit (1).
2. Push the compartment cover about .6 cm (1/4 inch) toward the front of the unit (2) and lift it off
the unit (3).
Figure 2-5

Replacing the Secure USB Compartment Cover

To replace the secure compartment cover:
1. Place the cover on top of the unit so it is offset about 0.6 cm (1/4 inch) toward the front of the
unit, allowing the tabs on the cover to align with the slots on the chassis (1).
2. Slide the cover toward the back of the unit until the cover is flush with the chassis (2).
3. Replace the screw (3).
Figure 2-6
Removing the secure USB compartment cover
Replacing the secure compartment cover
Removing and Replacing the Secure USB Compartment Cover 11