Brother HL-L5000D User Manual page 245

Error Message
No Paper MP
No Paper T1
No Paper T2
No Paper T3
No Paper T4
No Toner
No Tray T1
No Tray T2
No Tray T3
No Tray T4
Out of Memory
Print Data Full
Print Unable ##
Replace Drum
Replace Toner
Self-Diagnostic
Size Error
Cause
The MP tray is out of paper, or
paper is not loaded correctly in the
MP tray.
The machine failed to feed paper
from the indicated paper tray.
The toner cartridge or the toner
cartridge and drum unit assembly
is not installed correctly.
The paper tray is not installed or
not installed correctly.
The machine's memory is full.
The machine's memory is full.
The machine has a mechanical
problem.
It is time to replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
The toner cartridge is at the end of
its life. The machine stops all print
operations.
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
The paper size defined in the
printer driver is not supported by
the defined tray.
Action
Do one of the following:
• Refill paper in the MP tray. Make sure the
paper guides are set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
Do one of the following:
• Refill paper in the paper tray indicated on
the LCD. Make sure the paper guides are
set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
• Do not overfill the paper tray.
Remove the toner cartridge and drum unit
assembly. Remove the toner cartridge from the
drum unit, and reinstall the toner cartridge
back in the drum unit. Reinstall the toner
cartridge and drum unit assembly back in the
machine. If the problem continues, replace the
toner cartridge with a new one.
Reinstall the paper tray indicated on the LCD.
Press Cancel and reduce the print resolution.
Press Cancel and delete the previously stored
secure print data.
• Press and hold to turn the machine off,
wait a few minutes, and then turn it on
again.
• If the problem continues, contact Brother
customer service.
Replace the drum unit with a new one.
See Related Information: Replace the Drum
Unit.
Reset the drum unit counter.
See the instructions included with the new
drum unit.
Replace the toner cartridge with a new one.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Choose a paper size supported by the defined
tray.
240