Rear Panel - Yamaha TF5 Quick Manual

4-2 Rear panel

⑩ ⑨
1 OMNI OUT jacks
XLR-3-32 male output jacks that output analog audio
signals. These jacks are used mainly to output AUX
channels and STEREO channels. Nominal output level
is +4 dBu. You can select which signal is output on the
OMNI OUT screen.
2 ST IN jacks
Stereo input jacks that can be used for connecting a
CD player or other line level device. These jacks are
unbalanced female RCA jacks. Nominal input level is
-10 dBV.
3 INPUT jacks
Combination jacks that support both XLR and TRS
phone connectors. Use these jacks to connect mics
and instruments. Nominal input level is -62 dBu to +10
dBu. The head amp setting for each jack is saved in
memory.
① ②
⑧ ⑦ ⑥
4 NETWORK connector
RJ-45 jack used to connect the console to a
computer via an Ethernet cable (CAT5e or higher
recommended). This connector is used mainly to
control mix parameters or to edit Scene memories and
Libraries from the dedicated "TF Editor" program or the
"Monitor Mix" "TF StageMix" iPad app.
5 USB TO HOST connector
USB connector used to connect the console to a
computer, allowing the console to function as an audio
interface. Supports input and output for 34 channels
of 48 kHz, 24-bit audio. When using with a computer
running Microsoft Windows, the Yamaha Steinberg
USB Driver is required. When using a Mac, Core Audio
is used and therefore no extra drivers are required.
6 FOOT SW jack
Used for connecting an optional FC5 foot switch. You
can use the connected foot switch as an effect bypass
switch, a mute switch, or use it to tap the delay time.
③
⑤ ④
7 Expansion slot
8 Ventilation holes
9
0 AC IN connector
• Make sure the unit is turned off before connecting
• Disconnect the power cord from the outlet when
Allows you to install an NY card, such as the NY64-D
Audio Interface Card.
(Installing an NY card → page 22)
To prevent overheating, do not block the ventilation
holes.
Power switch
When the switch is in the position, the power is on.
When the switch is in the position, the power is off.
Connect the included power cord. When connecting
to a power outlet, first connect the power cord to the
console, then connect the power cord to the power
outlet.
CAUTION
or disconnecting the power cord.
the unit will not be used for extended periods of
time (page 8).
TF series Quick Guide
Panels
11