2-70 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Apply clutch fluid to the parts removed and to the inner
wall of the cylinder.
Take care not to scratch the piston or the inner wall of the
Apply silicone grease.
Clutch Lever Pivot Bolt
Clutch Lever Pivot Contact
Push Rod Contact
Install the push rod with the dust seal fitted into the
The push rod round end must be faced inwards.
Torque - Clutch Lever Pivot Bolt: 1.0 N·m (0.10 kgf·m, 8.9
Clutch Lever Pivot Bolt Locknut: 5.9 N·m (0.60
kgf·m, 52 in·lb)
Install the clutch master cylinder (see Clutch Master Cylin-
der Installation in the Clutch chapter).
Clutch Slave Cylinder Piston Seal Replacement
Remove the engine pulley outer cover (see Engine Pulley
Outer Cover Removal in the Final Drive).
Loosen the banjo bolt [A] at the clutch pipe lower end, and
tighten it loosely.
Unscrew the slave cylinder bolts [B] and detach the slave
cylinder with the pipe installed from the engine.
Pump the clutch lever until the piston comes out of the
Unscrew the banjo bolt and remove the slave cylinder [C].
Immediately wash away any clutch fluid that spills.
It may damage painted surfaces.
If the clutch slave cylinder is removed and left alone, the
piston will be pushed out by spring force.
Piston Seal [B]