2-66 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Apply brake fluid to the outside of the pistons, and push
them into each cylinder by hand .
Replace the friction boot [A] and dust boot [B] with new
Apply silicone grease to the sliding surface of the caliper
holder shafts [C].
Check that the guide [D] is in place on the caliper holder.
Install the pad spring [A] on the caliper as shown in the
Install the brake pads (see Rear Brake Pad Installation in
the Brakes chapter).
Wipe up any spilled brake fluid on the caliper with wet
Clutch Hose Replacement
Clutch fluid quickly ruins painted plastic surfaces;
any spilled fluid should be completely washed away
When removing the clutch hose, take care not to spill the
clutch fluid on the painted or plastic parts.
Left Radiator Shroud (see Radiator Shroud in the Frame
Left Footboard (see Left Footboard Removal)
Banjo Bolt [A] and washers
Remove the banjo bolt [A] and washers.
Pull out the damper [B] outward.