Periodic Maintenance Procedures
Set the dimmer switch to high beam position [A].
The high beam headlight should go on.
The high beam indicator light (LED) [B] should go on.
If the high beam headlight and/or high beam indicator light
(LED) does not go on, inspect or replace the following
Headlight Bulb (see Headlight Bulb Replacement in the
Electrical System chapter)
Dimmer Switch (see Switch Inspection in the Electrical
Push the engine stop switch to stop position.
The headlight should stay going on.
If the headlight and high beam indicator light (LED) does
go off, inspect or replace the headlight relay (see Relay
Circuit Inspection in the Electrical System chapter).
Headlight Aiming Inspection
Inspect the headlight beam for aiming.
If the headlight beam points to one side rather than
straight ahead, adjust the horizontal beam.
Headlight Beam Horizontal Adjustment
Turn the horizontal adjuster [A] on the headlight with a
screwdriver in or out until the beam points straight ahead.
Turn the adjuster clockwise to face the headlight to the
If the headlight beam points too low or high, adjust the
Headlight Beam Vertical Adjustment
Turn the vertical adjuster [A] in the headlight in or out with
a screwdriver to adjust the headlight vertically.
Turn the adjuster clockwise to face the headlight up.
ON high beam, the brightest points should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight to the proper an-
gle according to local regulations.
PERIODIC MAINTENANCE 2-45