Alternator Cover Bolts [A]
Alternator Cover [B]
Alternator Cover Installation
Using a high-flash point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to around grommets [A] of the alter-
nator lead and crankshaft sensor lead.
Sealant - Liquid Gasket, TB1211F: 92104-0004
Check that dowel pins [A] are in place on the crankcase.
Replace the alternator cover gasket [B] with a new one.
Alternator Cover Bolts [B] L = 70 mm (2.8 in.)
Alternator Cover Bolts [C] L = 50 mm (2.0 in.)
Torque - Alternator Cover Bolts: 12 N·m (1.2 kgf·m, 106
Run the leads correctly (see Cable, Wire and Hose Rout-
ing section in the Appendix chapter).
Install the removed parts (see appropriate chapters).
Alternator Stator Coil Removal
Alternator Cover (see Alternator Cover Removal)
Holding Plate Bolt [A] and Plate
Alternator Lead Grommet [B]
ELECTRICAL SYSTEM 16-31