If the reading is 12.6 V or more, no refresh charge is re-
quired, however, if the read is below the specified, refresh
charge is required.
Battery Terminal Voltage
12.6 V or more
Terminal Voltage (V) [A]
Battery Charge Rate (%) [B]
Refresh charge is required [C]
Remove the battery [A] (see Battery Removal).
Do refresh charge by following method according to the
battery terminal voltage.
This battery is sealed type. Never remove sealing
cap [B] even at charging. Never add water. Charge
with current and time as stated below.
Terminal Voltage: 11.5 ∼ less than 12.6 V
If possible, do not quick charge. If quick charge is
done unavoidably, do standard charge later on.
Terminal Voltage: less than 11.5 V
Increase the charging voltage to a maximum voltage of
25 V if the battery will not accept current initially. Charge
for no more than 5 minutes at the increased voltage then
check if the battery is drawing current. If the battery
will accept current decrease the voltage and charge by
the standard charging method described on the battery
case. If the battery will not accept current after 5 min-
utes, replace the battery.
Battery Charger [B]
Standard Value [C]
Current starts to flow [D]
Determine the battery condition after refresh charge.
Determine the condition of the battery left for 30 minutes
after completion of the charge by measuring the terminal
voltage according to the table below.
12.6 V or higher
12.0 ∼ lower than 12.6 V
lower than 12.0 V
1.8 A × 5 ∼ 10 h (see following
9 A × 1 h
1.8 A × 20 h
Charge insufficient → Recharge
Unserviceable → Replace
ELECTRICAL SYSTEM 16-29