K-ACT ABS (Equipped Models)
Visually inspect the connector terminals [A].
Replace the K-ACT ABS hydraulic unit or main harness
if either of the terminals are cracked, bent, or otherwise
If the K-ACT ABS hydraulic unit connector is clogged with
mud or dust, blow it off with compressed air.
Front Wheel Rotation Sensor Removal
The wheel rotation sensor should be handled care-
fully, never struck sharply with a hammer, or al-
lowed to fall on a hard surface since the wheel rota-
tion sensor is precision made. Be careful not to get
water or mud on the wheel rotation sensor.
Do not try to disassemble or repair the wheel rota-
Fuel Tank (see Fuel Tank Removal in the Fuel System
Disconnect the connector [A] and detach the connector
from the frame.
Front Wheel Rotation Sensor [C]
Front Wheel Rotation Sensor Installation
Installation is the reverse of removal.
Run the lead correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).