Starter Clutch Removal
Refer to the Clutch Removal in the Clutch chapter.
Starter Clutch Installation
Refer to the Clutch Installation in the Clutch chapter.
Starter Clutch Disassembly
Remove the clutch housing (see Clutch Removal in the
Pry the hook portions [A] and remove the plate [B].
Pull the one-way clutch [C] out of the clutch housing.
Remove the washer [D].
Starter Clutch Assembly
Install the washer [A] on the clutch housing.
Install the one-way clutch [B] so that the circlip side [C]
Fit the hook portions of the plate into the groove [D] of the
clutch housing securely.
Starter Clutch Inspection
Remove the starter motor (see Starter Motor Removal in
the Electrical System chapter).
Turn the torque limiter [A] by hand.
The torque limiter should turn clockwise freely [B], but
should not turn counterclockwise.
Left Side View [C]
If the torque limiter does not operate as it should or if it
makes noise, go to the next step.
Disassemble the starter clutch (see Starter Clutch Disas-
sembly), and visually inspect the clutch parts.
One-way Clutch [A]
Housing Part [B] of Clutch Housing
If there is any worn or damaged part, replace it.