Insert the needle bearing [A] to the input shaft while turn-
ing counterclockwise [B] the clutch housing.
Install the primary chain guide.
Apply a non-permanent locking agent to the threads of
the primary chain guide bolts, and tighten them.
Torque - Primary Chain Guide Bolts: 9.8 N·m (1.0 kgf·m, 87
Install the cam damper [A] while fitting the alignment notch
[B] of the splines onto the alignment tooth [C].
Spring Retainer [B] and Washer
Tighten the cam damper bolt [C] while holding the alterna-
tor rotor steady with the rotor holder (see Alternator Rotor
Installation in the Electrical System chapter).
Special Tools - Grip: 57001-1591
Rotor Holder: 57001-1726
Torque - Cam Damper Bolt: 69 N·m (7.0 kgf·m, 51 ft·lb)
Install the washer [A] and spring washer [B] so that the
"OUTSIDE" mark [C] faces outward.
Replace the clutch hub nut with a new one.
Apply molybdenum disulfide oil to seating surface of the
Hold the clutch hub steady with the clutch holder, tighten
the clutch hub nut.
Special Tool - Clutch Holder: 57001-1243
Torque - Clutch Hub Nut: 185 N·m (18.9 kgf·m, 136 ft·lb)