4-10 COOLING SYSTEM
Water Pump Removal
Drain the coolant (see Coolant Change in the Periodic
Alternator Cover (see Alternator Cover Removal in the
Electrical System chapter)
Impeller Bolt [A] and Washer
The impeller bolt has left-hand threads. Turn the bolt
clockwise and remove it.
Water Pump Installation
Replace the washer with a new one.
Tighten the water pump impeller bolt together with a new
washer by turning the bolt counterclockwise.
Torque - Water Pump Impeller Bolt: 12 N·m (1.2 kgf·m, 106
Install the removed parts (see appropriate chapters).
Water Pump Inspection
Check the drainage outlet passage [A] at the bottom of
the crankcase for coolant leaks.
If the mechanical seal is damaged, the coolant leaks
through the seal and drains through the passage. Re-
place the mechanical seal unit.
Water Pump Impeller Disassembly/Assembly
Remove the water pump impeller (see Water Pump Re-
The sealing seat [A] and rubber seal [B] may be removed
easily by hand.
Apply coolant around the surfaces of the rubber seal and
Install the rubber seal and sealing seat into the impeller by
pressing them by hand until the seat stops at the bottom
of the hole.
Install the water pump impeller (see Water Pump Instal-