Throttle Body Assy
Vacuum Hose [A]
Electronic Cruise Control Cancel Switch (Throttle) Lead
Throttle Position Sensor Connector [A]
Accelerator Position Sensor Connector [B]
Throttle Body Assy Holder Bolts [C]
Throttle Body Assy [D] (from Intake Manifold)
Throttle Cable Stopper Plate Screw [A]
Throttle Cables [C]
Throttle Body Assy [D]
Stuff a piece of lint-free clean cloth into the intake ports of
the intake manifold to keep dirt out of the engine.
If dirt gets into the engine, excessive engine wear
and possibly engine damage will occur.
Throttle Body Assy Installation
Check the throttle bores [A] for carbon deposits.
If any carbon accumulates, wipe the carbon off the throttle
bores, using a lint-free cloth [B] penetrated with a high
-flash point solvent.
Apply a thin coat of grease to the throttle cable lower ends.
Fit the accelerator cable end [A] and the decelerator cable
end [B] into the throttle pulley.
Hold the cables with the holder plate [C].
Torque - Throttle Cable Holder Plate Screw [D]: 2.0 N·m
(0.20 kgf·m, 18 in·lb)
Run the throttle cables correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
FUEL SYSTEM (DFI) 3-105